CCO-kit

The reversing valve regulates heating and cooling water flow in products including climate beams, comfort modules and radiation panels.

The valve supplies the above products with hot or cold water, which means that the whole product’s heat exchanger can be utilised and only one actuator with valve is required.

The design means that heating and cooling can never be run simultaneously, but both circuits will be in contact with one another which means that a very minute volume of hot water and cold water will be exchanged when the valve switches between heating and cooling.

It is important that systems are designed to be able to handle the system liquid moving between the cold and hot system.

Valve

• The valve casing is manufactured in brass
• Enclosure and lid are manufactured in PA6
• The shaft is manufactured in POM
• The outer enclosure is manufactured in galvanised sheet steel
• The flow distributor is manufactured in ceramic
• The O-rings are EPDM.

Actuator

• The outer casing is manufactured in PA6 and PA6.6
• The gear wheel is manufactured in POM.

• Connectors are supplied fitted to the valve. They can be unscrewed by hand and connected to Ø 12 mm copper pipes.
• Then attach the copper pipes to the connectors fitted on the valve.
• Finally screw the actuator into the valve shaft using the included screw (PH2), see section “Mounting Actuator on Valve".
• See also detailed information about e.g. water quality, assembly and commissioning in separate instructions at swegon.com.
• Installation should be performed by a qualified professional.
• The CCO kit does not require maintenance.