CASA Samba Smart

CASA SAMBA SMART - can be used with Swegon CASA Smart and Genius ventilation units or external roof fans.

CASA SAMBA removes cooking fumes outside of the building. It also removes excessive heat and humidity unlike the recirculating kitchen hoods. Good odour catching capacity enables efficient fume removal with lower airflows resulting to lower energy consumption, with less pressure difference and lower noise.

When connected to a ventilation unit it uses the fan in the ventilation unit. Therefore there is no need for a separate fan or exhaust ducting for the kitchen hood. This is also creates less sound in the kitchen compared to hoods that have fan inside of them. The ventilation mode can be controlled from the cooker hood (home/away/boost) and the ventilation unit automatically compensates for the extracted cooking air preventing negative pressure from occurring in the home. It is also possible to control an older AC ventilation unit using the ITFC transformer available as an accessory.

Cooker hood can also be connected to a separate roof fan, which is the most silent option for the users. It can be directly connected to external EC-fans and to older AC fans with a separate ITFC transformer.

CASA Samba is a slim cooker hood that fits kitchen cabinets of all depths. The smooth surfaces and wash proof metal grease filters are easy to keep clean. The lighting in the hood is made up of maintenance-free LED lights with adjustable brightness. The cooker hood with voltage protection (24 V) is equipped with a mains transformer – its power consumption is therefore low and the hood is always safe for the user. All electrical connections are located above the hood and are therefore quick and easy to connect during the installation phase.

STOVE GUARD - The cooker hood can be equipped with the Safera Safety stove guard. The stove guard helps to protect against the usual kitchen accidents by preventing the cooker from being left unsupervised while in use and cutting the power if you forget to turn off the cooker. The stove guard can be is easily installed in the specified area below the hood using tape. In addition to this, a power control unit that is approved for use (3-phase or 1-phase) is needed. Swegon also recommends installing a water leakage monitor (SA1)